VMD-L Mailing List
From: Osmany Guirola Cruz (osmany.guirola_at_biocomp.cigb.edu.cu)
Date: Fri Jun 25 2010 - 06:58:06 CDT
- Next message: John Stone: "Re: stereo problem with vmd"
- Previous message: John Stone: "Re: Add/Remove Bonds"
- Next in thread: John Stone: "Re: stereo problem with vmd"
- Reply: John Stone: "Re: stereo problem with vmd"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Hi,
I am having problems with the stereo view using vmd.
This is my hardware
QUADRO FX-3700 with DIN connector
Viewsonic VX2265wm 120Hz
60GX NUVISION
Whit driver 195.36.15 its impossible to see in stereo(ghosting image).
When i use the 195.36.24 driver i can see in stereo with a "little ghost
image" but acceptable and with a new problem, the top right corner of my
display is interlaced, all the time, using or not using the stereo.
then i switch to 195.36.31 and the problems remains
and my last choice was change to driver 256.35 and now the problem of
interlaced corner disappear but its impossible to see an stero image too
much ghosting
in all cases i checked the frequencies of the monitor and are OK..
Greetings
Osmany
- Next message: John Stone: "Re: stereo problem with vmd"
- Previous message: John Stone: "Re: Add/Remove Bonds"
- Next in thread: John Stone: "Re: stereo problem with vmd"
- Reply: John Stone: "Re: stereo problem with vmd"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]