Re: REMD segmentation fault

From: Jim Phillips (
Date: Fri May 13 2011 - 08:30:08 CDT

On Fri, 13 May 2011, Massimiliano Porrini wrote:

> My REMD simulation had been running fine for two days and then it stopped
> and produced the attached error message (I see a segmentation fault)

Yes, it looks like a segmentation fault to me too but without a traceback
there's no way to tell where or why.

> I tried to restart it but unsuccessfully.

What did you do to restart and how did it fail?

> Any idea about this error?
> I would like to know if this is a known fixable issue before I start
> again a new run.

You could try the new 2.8b2 release.


This archive was generated by hypermail 2.1.6 : Mon Dec 31 2012 - 23:20:15 CST