different output in processors

From: dora guzman (dguzman_at_uci.edu)
Date: Tue Feb 27 2007 - 14:18:24 CST

• Next message: pedro.borkowski_at_utoronto.ca: "Crystal Structure Analysis"
• Previous message: vivek behera: "Incorrect Atom Count"
• Next in thread: Marcos Sotomayor: "Re: different output in processors"
• Reply: Marcos Sotomayor: "Re: different output in processors"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Should it make a difference if a set of SMD simulations are run on one
processor versus multiple (14) processors? Can I still compare the data
relative to eachother? I seem to be getting much higher forces for the
simulations run on one processor compared to that run on 14.
Any comments?

thanks in advance.
-dora

• Next message: pedro.borkowski_at_utoronto.ca: "Crystal Structure Analysis"
• Previous message: vivek behera: "Incorrect Atom Count"
• Next in thread: Marcos Sotomayor: "Re: different output in processors"
• Reply: Marcos Sotomayor: "Re: different output in processors"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.6 : Wed Feb 29 2012 - 15:44:25 CST