Re: heating system

From: baxy (baxy_at_hi.htnet.hr)
Date: Sat May 26 2007 - 05:09:20 CDT

thank you for the advice but with reassignTemp the temp does not hold at
that point and i can't use the same comand twice to lower the temp again to
200K. is there some examples for applying temperature commands.

thank you

robert
>
> reassignTemp - p52 of the manual.
>
>
> On Fri, 25 May 2007, baxy wrote:
>
>> Hi,
>>
>>
>>
>> I have a problem with twice hitting the system. I wish to heat my system
>> to for example 300K and then after 100ps heat it up to 500K and keep it
>> at that temperature for next 100ps after that cool it again to 300K and
>> run the simulation for next ~ 10 ps. my question is how do i write a
>> script with which I can specify that after 100ps heat goes up to 500K and
>> than stays there for a while and after some time drops again to 300K. can
>> i do it by writting only one script or...
>>
>>
>>
>> Thanks for any help, appreciate it a lot.
>>
>>
>>
>> robert
>>
>>
>>

This archive was generated by hypermail 2.1.6 : Wed Feb 29 2012 - 15:44:45 CST