From: Shirley Hui (shirleyhui_at_alumni.uwaterloo.ca)
Date: Wed Jul 20 2005 - 20:25:51 CDT
If you have use of Matlab, you can use matDCD.
Call readDCD, ead into Matlab only the atoms you want (i.e. specify atoms
numbers of the non-water atoms from the pdb file you used to run the
Then call writedcd to write to another DCD file with only the non-water
atoms you read into Matlab above.
----- Original Message -----
From: "Stern, Julie" <jvstern_at_bnl.gov>
Sent: Wednesday, July 20, 2005 8:49 PM
Subject: namd-l: removing water from DCD
What is the best way to remove water
from the DCD file after it has been created?
Are there any postprocessing tools for this?
This archive was generated by hypermail 2.1.6 : Wed Feb 29 2012 - 15:40:58 CST