dielectric

From: Michael Grabe (mgrabe_at_itsa.ucsf.edu)
Date: Wed Dec 17 2003 - 11:30:59 CST

Zhanwu,

if you are doing an md simulation you really don't want to do that.
only for poisson-boltzmann or other continuum type analysis should
you put in a dielectric by hand of say 80.0 for water and say 2.0 for
lipid.

if you just want to do a standard md, use a value near 1.0 to 2.0
for the dielectric in the simulation. the fact that you are doing md
with the correct partial charges for water means that you
will get an 'effective' dielectric for the water filled regions near 80.

put a quicker answer is: you can't define different dielectrics
in different regions in NAMD (or at least i am pretty sure you can't).

write back if you want review type references for the use of
dielectric constants in different kinds of simulations.

michael

On Wednesday, December 17, 2003, at 08:24 AM, Liu, Zhanwu wrote:

> Dear all,
>
> How can I use different dielectric constant in the simulation, for
> example,
> 80 for bulk water and 1.0 for lipid?
>
> Thanks
>
> Zhanwu
>
> ---------------------------
> Zhanwu Liu, Ph.D.
> University of Pittsburgh
> Department of Anesthesiology
>

------------------------------------------------------------------------
--------------------------
Michael Grabe, Ph.D.
Post-doctoral Fellow
Howard Hughes Medical Institute
University of California, San Francisco
533 Parnassus Ave.
San Francisco, CA 94143
mgrabe_at_itsa.ucsf.edu
tel: ++ 415.476.6585
http://itsa.ucsf.edu/~mgrabe

This archive was generated by hypermail 2.1.6 : Wed Feb 29 2012 - 05:17:59 CST